DNF Controls 2034CL-O-PBIO vs.3.1 - Manual (Page 10)

10 2034CL-O, Vs. 3.1, 300 Clip Instant Access System, Odetics Protocol,
PBIO Option
d. Press [LOAD] to load the selected CLIP ID for playout.
e.
Locate the clip to the desired IN time. Press [IN] to mark the IN time.
f.
Locate the clip to the desired OUT time. Press [OUT] to mark the OUT time.
g. Repeat steps a. – f. until clips are loaded into the desired VTRs.
h. Set the GANG mode, if required.
6. VIEW THE CLIP ID OF THE CURRENTLY LOADED
CLIP
Press [SHIFT] + [LOAD]. The bottom line will show the name of the loaded clip.
1. LEARN A CLIP OR CLIP COMBINATION
a. LEARN ON THE PRODUCTION SWITCHER
1)
On ST300, Load a clip(s) on the desired VTR(s). (See “LOAD A CLIP”
section.) (Only for Odetics Control Mode.)
2)
Select and enable the Peripheral Device Addresses for the ST300.
3)
Do a LEARN to the desired REGISTER.
The ST300 will: LEARN (save) the VTR number, loaded CLIP ID and current
IN and OUT time into the REGISTER number in the ST300.
In BVW mode, the clip ID is not learned.
b. LEARN ON THE SHOTBOX
1)
Load clip(s) on the desired VTRs. (See “LOAD A CLIP” section.)
(Only in Odetics Control Mode.)
2) Press
[LEARN]. The LEARN indicator will turn on.
3)
Select the desired BANK and ShotKey.
4) Press
[LEARN] to exit at anytime.
NOTE: The [LEARN] key toggles LEARN mode on/off.
The controller will: LEARN (save) the VTR Number (1,2,3), loaded CLIP ID and
current IN and OUT time to the selected Cue Point.
In BVW mode, the clip ID is not learned.