Function table – DNF Controls 2034CL-O-PBIO vs.3.1 User Manual
Page 26
26
2034CL-O, Vs. 3.1, 300 Clip Instant Access System, Odetics Protocol,
PBIO Option
25. FUNCTION TABLE
FUNCTION
KEY PRESS
DESCRIPTION
GOTO
ENTERED
TIME
[SHIFT] + [RECUE]
Search the VTR to the manually entered time.
Use the ST300 numeric keypad.
To manually enter the desired time press [ENTER] or [RECUE].
NOTE: G
RASS
V
ALLEY
G
ROUP
Profile does not support TC or VITC
time search.
GANG
[SHIFT]+[VTR #1]
OR
[SHIFT]+[VTR #2]
OR
[SHIFT]+[VTR #3]
Individually press the VTR keys to be included in the gang; the LED
above the key will turn on. Press the VTR key again to remove from
gang; the LED above the key will turn off. Press [ESC] to exit.
The VTR LEDs that are on show the gang.
The flashing LED shows which VTR is currently selected.
FFWD
[FFWD]
Press and HOLD to FFWD. Release key to stop. Set WIND Speed in
MENU.
JOG
[JOG]
Select JOG mode and enable Wheel.
Label clip
[SHIFT] + [CLIPLIST]
Enter clip label on shotbox keyboard or optional PC keyboard.
LAST CUE
[LAST CUE]
Step to the previous Cue Point Location.
NEXT CUE
[NEXT CUE]
Step to the next Cue Point Location.
RECORD
[REC]
Places VTR into the Record mode selected by RECORD MODE in the
SETUP MENU. Press [RECORD] or [RECORD] + [PLAY].
REWIND
[RWD]
Press and HOLD to REWIND. Release key to stop. Set WIND Speed
in MENU.
SHUTTLE
[SHUTTLE]
Select SHUTTLE mode and enable Wheel.
SLOMO
[SLOMO] Press
[SLOMO] to slo-mo the VTR. Turn the Wheel (or move the T-
Bar, if available) to change the play speed.
Press [SLOMO] to STILL frame
OR press any transport key to exit SLOMO.
SLO-MO
SPEED
PRESET
[SHIFT] + [SLOMO] For
WHEEL
ONLY: Press [SHIFT] + [SLOMO] to preset the slo-mo
speed. Turn the Wheel to select desired speed.
Press [ESC] or any transport key to exit.
STOP
[STOP]
Press once to STILL frame VTR.
Press again to put VTR into STOP mode.
TIME MODE
SELECT
[TIME MODE]
Press to toggle between Timecode (TC), VITC (VT) or Tape Timer
(TM) display modes.
LOOP CLIP
[LOOP ENABLE]
Press to loop a whole clip or a part between IN and OUT points (if
marked).