Daktronics Venus DataStreamer - Manual (Page 61)

Creating Messages for the Panelized DataTrac 55
8. Click in the first field under the Field column in the table and select the information
to be displayed in that field of the table as shown in Figure 96.
9. In the Line and Character
columns, choose the line
and character on which
the field should be
displayed within each
cell. For example, line 1 is
the very top line of the
defined cell and character
2 is the second column
from the left of the
defined cell.
10. Click in the Width column
to set the maximum
number of characters
available for the field to
be displayed.
11. Click in the Height field to set the number of rows used to display the information.
Note: If a field is wider than the allowed width, set the height higher than one and
the data will wrap into the additional rows.
12. Click in the Justify and Color columns to set the appearance of the data in the field.
13. Click in the General column to set any necessary parameters for the field.
14. The Conditions field allows the monitoring of data and the modification of values
according to certain criteria. Refer to Section 8 for information on setting
conditionals.
15. Click Next.
Figure 96:Field Configuration Dialog