Daktronics 2000 Rodeo OmniSport - Manual (Page 9)

Introduction 1
Section 1: Introduction
This manual is designed to explain the operation of OmniSport ® 2000 timing console for rodeo events.
For additional information regarding the safety, installation, operation, or service of this system, refer
to the telephone numbers listed in Section 1.4.
1.1 Important Safety Instructions
 Read and understand all instructions, both general and for specific sports.
 Do not drop the device or immerse it in water.
 This device shall not be exposed to dripping or splashing, and no objects filled with
liquid shall be placed upon it.
WARNING! To reduce the risk of fire or electric shock, do not expose this device to rain
or moisture.
 An internal battery allows the timer to continue operation for approximately 10 minutes
in the event of a power failure.
CAUTION! DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED.
REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE.
WARNING! Do not expose batteries to excessive heat, such as direct sunlight or
open fire.
 Never yank the power cord to pull the plug from the outlet. Grasp the plug and pull to
disconnect.
 Do not let the power cord touch hot surfaces or hang over the edge of a table that could
damage or cut the cord.
 If an extension cord is necessary, use a three-pronged polarized cord. Arrange the cord
with care so that no one will trip over or pull it out.
 Before using an extension cord, inspect the cable thoroughly and verify its compliance
with the local electric codes.
 Always turn off and unplug the control equipment when it is not in use.
 To avoid electrical shock, do not disassemble the control equipment or electronic controls
of the display. Incorrect reassembly can cause electric shock and faulty operation or
permanent damage to the circuits. Failure to follow this safeguard will make the
warranty null and void.
 Inspect console for shipping damage such as rattles and dents, and verify that all
equipment is included as itemized on the packing slip. Immediately report any problems
to Daktronics; save all packing materials if exchange is necessary.
As a safety feature, this device has a three-wire, ground-type plug equipped with a third
(grounding) pin. This plug only fits into a grounding-type power outlet. The outlet shall be
installed near the console and easily accessible. If unable to insert the plug into the outlet,
contact a qualified electrician to replace the obsolete outlet.