Daktronics 2000 Rodeo OmniSport - Manual (Page 26)

18 General Console Features & Operation
Multiple controller systems typically use Broadcast 1 and Channel 1 for the first controller
and Channels 2-8 for all remaining controllers. All radio receivers in the system must be set to
Broadcast 1 (BCAST 1).
Multiple Controller with Multiple Broadcast Systems Channel Setting
In a multiple controller system with multiple broadcast groups, there are many consoles that
control multiple scoreboards and/or scoreboard groups. The radio receiver inside the
scoreboard is set to broadcast group 1–4 (Gen V) or 1–8 (Gen VI). By changing the console
settings to the specific broadcast group address, a single console can control all scoreboards
or specific groups of scoreboards.
Typically, all multiple controller systems will use BCAST 1, CHAN 1 for the first controller in
Broadcast Group 1 and BCAST 2, CHAN 1 for the first controller in Broadcast Group 2. All
other consoles in a group are added sequentially.
Basic Operation of Radio Settings
Display Action
The LCD will toggle between
these 2 screens.
The LCD shows the current radio settings along with a prompt
to accept or modify these values.
If the radio settings are correct press [ENTER].
If these values are incorrect press [CLEAR], and the LCD at
bottom left is shown, allowing edit of the channel or broadcast
group setting.
Use the number keypad to enter the desired broadcast group
and press [ENTER] to accept. The asterisk will move to the
channel setting.
Edit the channel number to the desired value and press
[ENTER] to accept.
Broadcast
Group Channel
Setting
Control Scoreboards
0 0 All Scoreboards
1
0 All in BCAST Group 1
1-8
Set to corresponding BCAST 1
Channel
8*
0 All in BCAST Group 8
1-8
Set to corresponding BCAST 8
Channel
* Gen V radio receivers have only 4 groups; also, on broadcast
groups 2 and 4, only channels 1-4 may be used.
ENTER TO ACCEPT
CLEAR TO MODI FY
BCAST GROUP 1*
RADI O CHAN 01
RADI O SETTI NGS
BCAST X CHAN YY