Daktronics 2000 Rodeo OmniSport - Manual (Page 24)

16 General Console Features & Operation
Clear/No
The [CLEAR/NO] key has two functions:
 Clears the LCD of numerical information.
 Serves as [NO] for input prompts (N).
3.3 Built-in Printer
Daktronics OmniSport 2000 console has a convenient built-in thermal
printer which gives results printouts in under 10 seconds.
Correct Paper Installation
1. Remove the cover from the printer by turning the knob with the
arrow to the left 1 /
4
turn, or until the arrow points left. Remove the
cover by lifting up and forward on the knob (Figure 24).
2. Remove the old roll of paper.
3. Using a pair of scissors, cut the new roll of paper off to make
the end of the paper square.
4. Place the roll of paper into the printer compartment so that
the paper feeds up from underneath the roll (Figure 25). If the
paper is placed incorrectly (Figure 26), the printer will act like
it is printing, but no text will appear on the paper.
5. Place the newly cut squared edge of the paper into the back
side of the black rubber roller on the printer. The printer
should automatically advance—pulling the paper through
the printer.
6. Place the cover back on and turn the latch to secure.
The thermo printer paper can be ordered from Daktronics—part
# SF-1034. Thermo printer paper is also readily available at
office supply stores (58mm wide and 165' long max).
3.4 Startup
When the OmniSport 2000 timer is initially powered up, the LCDs appear as shown below.
If the timing console includes a radio, read Section 3.5. If the console does not, skip ahead to
Section 3.6 on how to receive software updates from Daktronics. For further explanations on
rodeo timing console operations, refer to Section 3.
Figure 24: Console
Printer
Figure 25: Correct Paper Feed
Figure 26: Incorrect Paper Feed
OMNI SPORT 2000
RODEO TI MI NG
VERSI ON 13.01.25
ED-14865
DAKTRONI CS, I NC
BROOKI NGS SD