Daktronics 2000 Rodeo OmniSport - Manual (Page 46)

38 Rodeo Menus & Settings
MENU-SETUP
3-NETWORK
MENU-SETUP
1-NETWORK ENABLE
MENU-NETWORK
2-MAC ADDRESS
MENU-NETWORK
3-I P ADDRESS
Photocell Switch
Photocells can be configured for Normally Open or
Normally Closed contacts via a switch setting on the
photocell eye. In most cases, the photocells will be set to
Normally Closed.
 Press [1] for normally closed photocell contacts. Press [ENTER] to save.
 Press [2] for normally open photocell contacts. Press [ENTER] to save.
5.6 Setup Network Menu
This menu is used to configure various network settings for
outputting Real-Time Data (RTD) to displays and connecting
to DakStats Rodeo software.
Network Enable
This menu sets the ETHERNET jack output on or off. If the
jack is not needed, it can be turned OFF (default).
Use [←][→] to toggle between ON/OFF and then press [ENTER] to save.
Note: If this setting is set to OFF, all of the menus below will be disabled.
MAC Address
This menu allows the operator to verify the MAC address
of the console. The MAC Address cannot be edited. Press
any key to exit the menu.
IP Address
This menu allows the operator to set or verify the IP address
of the console. The default setting is shown below.
MENU-PCELL SETUP
3-PCELL SWI TCH
From Main Menu – [3]>[2]>[3]
PHOTOCELL SWI TCH
1-NORMAL CLOSED PHOTOCELL SWI TCH
2-NORMAL OPEN
MENU-NETWORK
NETWORK: ON *
From Main Menu – [3]>[3]>[1]
MENU-NETWORK
NETWORK: OFF*
MAC ADDRESS
09:ec:03:02:7d
From Main Menu – [3]>[3]>[2]
I P ADDRESS
192*168. 0. 55
From Main Menu – [3]>[3]>[3]
From Main Menu – [3]>[3]