Section 6: judges’ console operation, 1 console setup, 2 scored events operation – Daktronics 2000 Rodeo OmniSport User Manual
Page 49: Section 6, Judges’ console operation, Console setup, Scored events operation
Judges’ Console Operation
41
ENTER JUDGE #
-*
JUDGE 1:
JUDGE 1: ^^.^*
#1262
JUDGE 1: ^^.^* R
#1262 ^^.^ S
JUDGE 1: ^^.^* C
#1262 ^^.^ S
JUDGE 1: 20.0
#1262 OK
JUDGE 1: 20.0
ACCEPTED
Section 6:
Judges
’ Console Operation
The judges’ consoles are used to enter scores during scored events. The OmniSport rodeo timer can be
set to use 1, 2, or 4 for Scored Events or 1, 2, 3, or 5 for Cutting. Refer to the system risers Drawing B-
220003 and Drawing A-230608 for connection details.
For more information about the RC-100 wireless system, refer to the Remote Control System RC-100 All
Sport Operation Manual (ED-15133), available online a
6.1 Console Setup
When the consoles are first connected to the OmniSport
timer they will prompt the user to enter a judge number.
The LCD on the judge’s console will display this prompt and wait for the user to enter a
number from one up to the maximum number of judges’ consoles the OmniSport is
configured to use. If the number has already been used by another judge or is above the
number of judges the console will beep and wait for a new
number. Once the judge’s console has selected a judge
number, the LCD will display which judge number it is set
for as shown at right.
6.2 Scored Events Operation
The request for scores will show on the judges’ consoles after
the timer has stopped. Enter the score(s), and then press
[ENTER] to confirm. If the score is out of the acceptable
range, the console will beep and wait for a different score.
After a valid score is entered, “OK” will appear by the
competitor number. Once the score is accepted, the console
will indicate this.
The four modes of score entry are shown below. Refer to Section 4.5 for selecting score modes.
Combined Mode
In combined mode, the total score for rider and stock is
entered.
Separate Mode
In separate mode, the rider and stock scores are entered
separately.
Total/Stock Mode
In total/stock mode, the total score is entered first, and then
the stock score is entered.