Daktronics 2000 Rodeo OmniSport - Manual (Page 42)

34 Rodeo Menus & Settings
MENU-SCOREBOARD
2-SCORE DI SPLAY
MENU-SCOREBOARD
3-DI MMI NG
Dimming Levels:
0 = NONE (full bright)
1 = 90%
2 = 80%
3 = 70%
4 = 60%
5 = 50%
6 = 40%
7 = 30%
8 = 20%
9 = 10% (dimmest)
 Press [1] to set the scoreboard output ON. Press [ENTER] to save.
 Press [2] to set the scoreboard output OFF. Press [ENTER] to save. The scoreboard will
be blank until: the start of the next event, [RESET] is pressed to re-display data of the
last event, the scoreboard is turned back ON in the menu, or [SCOREBOARD ON/OFF]
is pressed.
When to use this:
 The scoreboard is displaying false information due to equipment or operator error and
needs to be blanked.
 The error is corrected and the scoreboard output can be turned back on.
Score Display
This menu selects whether to show scores on the scoreboard.
 Press [1] to show scores on the scoreboard. Press [ENTER] to save.
 Press [2] to not show scores on the scoreboard. Press [ENTER] to save.
When to use this:
 There’s only enough room on the scoreboard to show either time or score at one time, and
time is the preferred information to show.
Dimming
This menu is used to adjust the scoreboard dimming
(brightness) level. The dimming setting only applies to
scoreboards configured to receive multi-drop protocol.
Use the number keypad to select one of the values shown in the
table to the right, or use [←][→] to toggle through the levels. To
save the setting, press [ENTER]. To return to the Dimming Menu
without saving, press [CLEAR].
When to use this:
 In low light conditions the scoreboard may be too bright.
 In direct sunlight the scoreboard may need to be turned
to full bright.
From Main Menu – [1]>[2]
SCORE DI SP= ON
1=ON 2=OFF
From Main Menu – [1]>[3]
LEVEL(0-9):
3-DI MMI NG NONE