Daktronics 2000 Rodeo OmniSport - Manual (Page 31)

Rodeo Timer Operations 23
Cutting
The Cutting mode is a scored event, but it uses a different score entry and calculation.
Press [CUTTING] to select the Cutting mode.
When in Cutting mode:
 The left LCD shows the leader number and score along with the current (now up) number.
 The center LCD shows the current score, the official timer (T), the timer direction ( { or } ),
and the default horn time (H).
 The right LCD shows the scores from each configured judge console and the photocell
status (C). Refer to the table on the previous page for descriptions of possible photocell
statuses. For more information about judge’s console operation, refer to Section 6.
Note: If a judge console is not properly connected/communicating, a “?” will be next to it.
External Timing
External Timing can be selected for Manual Timing, Automatic Timing, and Cutting modes.
The external setting is needed when using wireless photocells (refer to Section 2.1).
The information shown on each LCD changes slightly for all timing modes to indicate
External Timing is selected.
External Manual Timing 1 Button:
External Automatic Timing:
External Cutting:
Note: When set to External Timing, the photocell status (C) will always be “- -” (Normally
Closed) or “OK” (Normally Open), whether the photocells are in alignment or not. This is
because the status is not passed from the external timer to the OmniSport console.
LEAD# 1262/185.0
CURRENT# 169
CUTTI NG 185.0
2:30.00} H=2:30 J1=60.0 J2=62.0
J3=63.0 OK
LEAD# 1262/11.47
CURRENT# 169
 : 0.000 --
EXTERN TI MI NG J1
1 TI MER H=:25
LEAD# 1262/11.47
CURRENT# 169
 : 0.000
 : 0.000 -- AUTO TI MI NG J1
EXT TI ME
LEAD# 1262/185.0
CURRENT# 169
CUTTI NG 185.0
 : 0.00} EXTERN J1=60.0 J2=62.0
J3=63.0 --