Power connection, Rodeo timing interface connection, Judges’ console connection – Daktronics 2000 Rodeo OmniSport User Manual
Page 16
8
Timing System Setup
Power Connection
Connect the power adaptor to the J13 POWER IN jack (Figure 3), and plug the other end into
a 100-240 VAC outlet. Use the rocker switch on the rear of the unit to power it ON and OFF.
Rodeo Timing Interface Connection
The Rodeo Timing Interface is connected to the OmniSport 2000 console via a 15-pin cable
(W-1264). Connect the male end of the cable to the J7 SWITCH INPUTS on the rear of the
OmniSport 2000 (Figure 4), and connect the female end of the cable to the TO A/S 5100 jack on
the rear of the Rodeo Timing Interface (Figure 5). Refer to Section 2.2 for more connections on
the Rodeo Timing Interface.
Judges’ Console Connection
Typically, an RC-100 wireless base station will be
plugged into the J14 NEAR END jack on the rear of the
OmniSport 2000 (Figure 6).
For more information about the RC-100 base station,
refer to the Remote Control System RC-100 All Sport
Operation Manual (ED-15133), available online at
Figure 3: Power Connection
Figure 4: SWITCH INPUTS
Figure 5: TO A/S 5100
Figure 6:
Judges’ Console Connection