Daktronics 2000 Rodeo OmniSport - Manual (Page 29)

Rodeo Timer Operations 21
Section 4: Rodeo Timer Operations
Reference Drawings:
Rodeo Photocell Interface Connector Assignments............................................ Drawing A-147806
Insert, 0L-212281, OmniSport 2000 Rodeo Timer .............................................. Drawing B-212381
System Riser Diagram; OmniSport 2000 Rodeo setup....................................... Drawing B-220003
4.1 General Rodeo Timer Information
The OmniSport 2000 Timer can be used in four separate modes of operation. Three of the four
modes can be used with an external timer using wireless photocells.
Manual Timing Mode
Manual Timing mode is used for events where a competitor’s time determines the place
winner. Timing inputs are one, two or three manual pushbuttons connected to the Daktronics
photocell interface. Examples of timed events using timer buttons are steer wrestling, calf
roping, and team roping. Press [1 TIMER], [2 TIMER], or [3 TIMER] to select Manual
Timing mode with the appropriate number of timer button inputs.
When in Manual Timing mode:
 The left LCD shows the leader number and time along with the current (now up) number.
 The center LCD shows the official timer (T) along with each timer value (1, 2, or 3). With
1 or 2 TIMER selected, photocell status is also visible. Refer to the table on the following
page for descriptions of possible photocell statuses.
 The right LCD shows the default horn time (H), the current number of timers selected,
and the judges’ console status (J1 or J? if not properly connected/communicating). For
more information about judge’s console operation, refer to Section 6.
Manual Timing 1 Button:
Manual Timing 2 Buttons:
Manual Timing 3 Buttons:
LEAD# 1262/11.47
CURRENT# 169
 : 0.00 OK
MANUAL TI MI NG J1
1 TI MER H=:25
LEAD# 1262/11.47
CURRENT# 169
 : 0.00 OK
 : 0.00 : 0.00 MANUAL TI MI NG J1
2 TI MERS H=:25
LEAD# 1262/11.47
CURRENT# 169
 : 0.00 : 0.00
 : 0.00 : 0.00
MANUAL TI MI NG J1
3 TI MERS H=:25