Daktronics 2000 Rodeo OmniSport - Manual (Page 13)

Introduction 5
1.5 Console Revision History
Version 4.10.17 Release date: 17 October 2004
 Initial software release
Version 5.6.08 Release date: 8 June 2005
 In die C3 of 80C390, the SMOD_1 bit for Serial Port 1 seems to be ignored and the baud
rate is always doubled (WDCON.7=1) so the reload values of Timer 1 were adjusted to
work with this as doubled.
 Added an H-segment on digit two of the clock in address 1 for a caption control.
 Removed the selection in the menu for start of timer using judge number 1.
Version 5.9.26 Release date: 26 September 2005
 Added the ability to take a time input from the FarmTek timer for barrel racing to show
on our displays.
Version 5.12.02 Release date: 2 December 2005
 Added a Cutting mode that uses 1, 2, 3 or 5 judge’s consoles to score the event.
 Added a Bubble Time/Score key function to the console and in RTD.
 Added a Cattle number key function to the console and in RTD.
 Added a previous Time/Score section in the RTD.
 Added a Clear Previous key function to the console.
 Added an Enable/Disable Photocell key to the console.
 Added the ability to receive a time input from the FarmTek timer in Timed Events and
Cutting Events.
 Added the ability to Start, Stop and Reset from all judge consoles in Scored Events.
 Added to the printout for a scored event, which judge console started and stopped the
timer.
 Added the entry of an extra judge console to be used as a Start, Stop console.
 Added a Menu selection to select if any judge's console can Start/Stop the timer.
 Added a warning time in cutting and penning that sounds a .5 second horn when the
warning time is reached.
 Changed the Reset Judges key to get the judges consoles to exit scoring if no score was
entered.
Version 6.2.16 Release date: 16 February 2006
 Fixed a problem when configured for 1 judge, the score always came back with the status
set to reride on.
 Fixed a problem that the Cutting horn time is using the scored event horn time.
 Fixed a problem of the Warning horn is not sounding when clock is counting down.
Version 6.9.21 Release date: 21 September 2006
 Fixed a problem with entering the # of judges in cutting mode, as it would not let all of
the allowed judges be entered.
 Fixed a problem when timing with Farmtek in external timing, if the timer was turned off
or disconnected, the OmniSport timer would not allow the user to switch to a different
timing mode.