Comtech EF Data DD2401 VME - Manual (Page 45)

DD2401 VME L-Band Demodulator Card Installation & Operational Manual User Interfaces
MN-VME2401 – Rev. B 4-21
<1>
<1>
<4>
<4>
<2>
<2>
<2>
<4>
<2>
<1>
<1>
<1>
<1>
<1>
<1>
<1>
<1>
Latched Comm.
Alarm
Reserved
Error Counter
Test 2047 Error
Counter
Raw BER
Mantissa
Corrected BER
Mantissa
Eb/No
Offset Frequency
Test 2047
Mantissa
Raw BER
Exponent
Corrected BER
Exponent
Test 2047 BER
Exponent
Offset Frequency
Sign
BER/EbNo Status
Buffer Percent Full
Input Level
Input Level State Bit 0 = -12 V Alarm
Bit 1 = +12 V Alarm
Bit 2 = +5 V Alarm
Bit 3 = Temperature
Bit 4 = Interface FPGA Fault
Bit 5 = Battery Fault
Bit 6 = RAM/ROM Fault
Bit 7 = Spare
(0 = Pass, 1 = Fail)
Ignore
Unsigned Binary Value
Unsigned Binary Value
Bytes 1 - 2 = Unsigned Binary Value Raw BER
Bytes 1 - 2 = Unsigned Binary Value Corrected BER
Unsigned Binary Value, 2 Decimal Places Implied
Unsigned Binary Value in Hz, Pos/Neg Indicated Below
Bytes 1 - 2 = Unsigned Binary Value Test 2047 BER
Byte 3 = Unsigned Binary Value Exponent
Byte 3 = Unsigned Binary Value Exponent
Byte 3 = Unsigned Binary Value Exponent
0 = Offset Frequency Pos, 1 = Offset Frequency Neg
Bit 0 = Raw BER and Corrected BER Status (1 = Valid)
Bit 1 = Test 2047 BER Status (1 = Valid)
Bits 2 - 3 = EbNo Status (0 = EbNo is Invalid, 1 = EbNo is Valid, 2 =
EbNo is Smaller Than Indicated Value, 3 = EbNo is
Greater Than Indicated Value)
Bit 4 = Raw BER Counter Overflow (1 = overflow condition)
Bit 5 = Test 2047 BER Counter Overflow (1 = overflow condition)
Bits 6 & 7 = Spares
Unsigned Binary Value Representing % Buffer Full (0 - 100 in 1%
Steps)
Unsigned Binary Value in -1 dB Steps, Negative Sign Implied
Signed Binary (0 = Equal to, 1 = Greater Than, -1 = Less Than Value