Comtech EF Data DD2401 VME - Manual (Page 42)

User Interfaces DD2401 VME L-Band Demodulator Card Installation & Operational Manual
4-18 MN-VME2401 – Rev. B
*<1>
*<1>
*<1>
*<2>
*<2>
*<1>
*<1>
*<30>
*<1>
Receive IDR
Overhead Mode
Receive IDR / IBS
Backward Alarms
Mask
Interface Type
Receive ESC
Audio #1 Volume
Receive ESC
Audio #2 Volume
Alarm 5 Mask
Insert Mode
Insert Map
Insert Alarm Mask 0 = Voice, 1 = 64 K Data
Note: The following byte applies only if an IDR OR IBS
interface card is installed and the Receive Mode is set to
IDR Mode. If not, ignore
Bit 0 = IDR Backward Alarm 1 / IBS Backward Alarm
Bit 1 = IDR Backward Alarm 2
Bit 2 = IDR Backward Alarm 3
Bit 3 = IDR Backward Alarm 4
Bits 4 - 7 = Spares
(0 = Mask, 1 = Allow)
Note: The following byte applies only if an IDR OR IBS
interface card is installed and the Receive Mode is set to
IDR Mode. If not, ignore
If G.703 Daughter Card Installed
0 = G.703 Unbalanced E1, 1 = G.703 Balanced E1, 2 = G.703 T1,
B8ZS
If synchronous Multiprotocol daughter card is installed:
0 = V.35, 1 = RS-422, 2 = RS-232
Note: The following two bytes apply only if an IDR OR IBS
interface card is installed and the Receive Mode is set to IDR
Mode. If not, ignore
-20 to +10, Signed Binary Value in dB
Note: The following two bytes apply only if an IDR OR IBS
interface card is installed and the Receive Mode is set to IDR
Mode. If not, ignore
-20 to +10, Signed Binary Value in dB
Bit 0 = IBS Satellite Multiframe Fault
Bit 1 = IBS Satellite Frame Fault
Bit 2 = Spare
Bit 3 = IBS Alarm if BER < 10-03
Bit 4 = IBS Prompt Alarm
Bit 5 = IBS Service Alarm
Bit 6 = Turbo Codec Lock Fault
Bit 7 = Spare
(0 = Mask, 1 = Allow)
0 = Disable, 1 = T1-D4, 2 = T1-ESF, 3 = PCM-30, 4 = PCM-30C, 5 =
PCM-31, 6 = PCM-31C, 7 = T1-SLC96, 8 = T1-D4-S, 9 = T1-ESF-S
Mapping of Satellite Channels to insert Terrestrial Timeslots
Bit 0 = Frame Lock Fault