Comtech EF Data DD2401 VME - Manual (Page 26)

User Interfaces DD2401 VME L-Band Demodulator Card Installation & Operational Manual
4-2 MN-VME2401 – Rev. B
4.3 Terminal Port User Interface
Each demodulator has a Terminal Port Connection (J1) that allows for complete control and
monitoring of the demodulator parameters and functions via an RS-232 Serial Interface.
The factory default setup parameters are as follows:
Emulation Type:
VT100 (can be changed)
Baud Rate: 19200
Data Bits: 8
Parity: No Parity (Fixed)
Stop Bits: 1 stop bit
4.3.1 Connecting the Terminal
1. Connect the computer to the Remote Connector (J5) on the rear of the unit using
the RS-232 Cable.
2.
Enable the terminal by selecting Terminal Mode (located under the System -
Control Mode Menu) from the front panel.
3.
Verify that your emulation software is set to the following:
 8 data bits
 no parity
 1 stop bit
Modify the selection, if necessary, to match the settings (the Front Panel
‘SYSTEM’ Sub-Menu contains all the Terminal Emulation Controls).