Comtech EF Data SDM-100A - Manual (Page 84)

Operation SDM-100A Satellite Modem
3–50 Rev. 0
M&C Module
Firmware Displays M&C module firmware version.
Upon entry, the date of release of this firmware will be displayed. This
is a status window only.
FPGA Firmware Displays firmware version of the Field Programmable Gate Array.
Upon entry, the date of release of this firmware will be displayed. This
is a status window only.
DSP Firmware Displays the firmware version installed in the Digital Signal Processor
(DSP).
Upon entry, the date of release of this firmware will be displayed. This
is a status window only.
Master Reset Master reset function.
CAUTION
When a hard reset is initiated, the modem hardware is reset, and
all default configuration settings will be installed. When a soft
reset is initialized, the modem hardware will be reset, but the
initial firmware configuration settings will be saved.
Press [ENTER]
once to access Soft. Press [ ↑ ] or [ ↓ ] to alternate
between Hard and Soft until the desired type is visible. Press
[ENTER]. If Soft has been selected, press [ENTER]
again to reset the
modem. If Hard is selected, press [ → ] until the cursor is on YES, and
press [ENTER].