A.5 stored faults – Comtech EF Data SDM-100A User Manual
Page 180
Remote Control Operation
SDM-100A Satellite Modem
A–28
Rev. 0
A.5 Stored Faults
Information on stored faults is returned when requested. If no stored fault exists for a given fault number,
the words “NO Fault” will be returned instead of the normal time/date status information.
The following symbols are commonly used to define the stored faults status commands:
• #
Fault number (0 to 9). “0” is the first fault stored.
• hh
Hours in 24-hr. format.
• mm Minutes.
• ss
Seconds.
• MM Month.
• DD Day.
• YY Year.
Modulator
Stored
Faults
Command:
Response:
MOD_xxx'cr'
SYN_xxx'cr'
DCS_xxx'cr'
ICH_xxx'cr'
QCH_xxx'cr'
AGC_xxx'cr''lf']
Module (OK/FLT)
IF Synthesizer (OK/FLT)
Data Clock Synthesizer (OK/FLT)
I Channel (OK/FLT)
Q Channel (OK/FLT)
AGC Level (OK/FLT)
Demodulato
r Stored
Faults
Command:
Response:
MOD_xxx'cr'
CD_xxx'cr'
SYN_xxx'cr'
ICH_xxx'cr'
QCH_xxx'cr'
DSCR_xxx'cr'
BERT_xxx'cr''lf']
Demod Module (OK/FLT)
Carrier Detect (OK/FLT)
IF Synthesizer Lock (OK/FLT)
I Channel (OK/FLT)
Q Channel (OK/FLT)
Descrambler (OK/FLT)
BER Threshold (OK/FLT)
Interface
Transmit
Side Stored
Faults
Command:
Response:
CLK_xxx'cr''lf']
TAC_xxx'cr' (See
Note)
Selected Transmit Clock Activity (OK/FLT)
Transmit Audio Clip (OK/FLT)
Note: Status only returned when ADPCM board is installed.
Interface
Receive
Side Stored
Faults
Command:
Response:
CLK_xxx'cr'
UNFL_xxx'cr'
OVFL_xxx'cr''lf']
RAC_xxx'cr' (See
Note)
DMXL_xxx'cr' (See
Note)
HOOK_xxx'cr' (See
Note)
Selected Buffer Clock Activity (OK/FLT)
Buffer Underflow (OK/FLT)
Buffer Overflow (OK/FLT)
Receive Audio Clip (OK/FLT)
Demultiplexer Lock (OK/FLT)
Remote Off Hook Fault (OK/FLT)
Note: Status only returned when ADPCM board is installed.
Common
Equipment
Stored
Faults
Command:
Response:
M&C_xxx'cr'
INT_xxx'cr'
BAT_xxx'cr'
+5_xxx'cr'
+12_xxx'cr'
-12_xxx'cr''lf']
Monitor & Control Module (OK/FLT)
Data Interface Module (OK/FLT)
Battery/Clock (OK/FLT)
+5V Power Supply (OK/FLT)
+12V Power Supply (OK/FLT)
-12V Power Supply (OK/FLT)