2 system installation – Comtech EF Data SDM-100A User Manual
Page 28

Installation
SDM-100A Satellite Modem
2–2
Rev.
0
6. Check the equipment against the packing list shipped with the equipment to
ensure that the shipment is complete.
7. Refer to Section 2.2 for further system installation instructions.
2.2 System Installation
Install the modem as follows:
1. Mount the modem chassis in the assigned position in the equipment rack. Refer
to Figure 2-1 for an illustration of a typical rack elevation for an M:N system.
2. Connect the cables to the appropriate locations on the rear panel. Refer to
Section 2.4 for connector pinouts, placement, and functions.
3. Before applying power, read and become familiar with Chapter 3.
Verify all jumper settings are correctly set for remote operation. Refer to
Chapter 4 for jumper settings.
4. Turn on the power switch (located on the rear panel).
5. Check for proper TX output signal level and spectrum.
6. Check for proper RX input signal level and spectrum.
7. If there are any problems with the installation, refer to Chapter 5 for
troubleshooting the system.