5 remote aupc – Comtech EF Data SDM-100A User Manual
Page 70

Operation
SDM-100A Satellite Modem
3–36
Rev.
0
SDM-100 "TYPE"
VER: 14.7.4
FUNCTION SELECT
REMOTE AUPC
REMOTE AUPC
STATUS:
BB LOOP BACK
STATUS:
ON
OFF
ACCESS TO
SUBMENU
CONDITIONAL OR
OPTION-DEPENDENT
Parameter Information
Key:
ON
OFF
Figure 3-10. Remote AUPC (SDM-100 Operation)
3.2.1.5 Remote AUPC
Remote AUPC
Status:
Programs the modem for remote AUPC.
On entry, the current status is displayed. Press [
↑
] or [
↓
] to select ON
or OFF. Press [ENTER]
to execute the change.
BB Loop Back
Status:
Programs the modem for baseband loopback operation (test mode).
When baseband loopback is turned on, the data and timing signals
are hard-wired (via relays) from the demodulator to the modulator on
the modem side of the interface. The DTE baseband signals are also
looped back from the transmitter data and clock to the receiver data
and clock on the customer side of the interface. This is a
bi-directional loopback of the baseband data. Refer to Figure 3-28 for
a block diagram of baseband loopback operation.
On entry, the current status is displayed. Press [
↑
] or [
↓
] to select ON
or OFF. Press [ENTER]
to execute the change.