Comtech EF Data SDM-100A - Manual (Page 157)

SDM-100A Satellite Modem Remote Control Operation
Rev. 0 A–5
Set
Modulator
Output
Power Level Command:
Response:
Status:
Response:
>add/MOP_snn.n'cr''lf']
>add/MOP_snn.n'cr''lf']
Where: snn.n = -30.0 to -5.0, in 0.1 steps (nominal range in
dBm).
Notes:
1. The nominal power range is modified relative to the
value specified by the modulator power offset
(MPO_).
2. The MOP_ command will return status only when
local AUPC is enabled.
Scrambler
Enable Command:
Response:
Status:
Response:
>add/SE_xxx'cr''lf']
>add/SE_xxx'cr''lf']
Where: xxx = ON or OFF.
Differential
Encoder
Enable Command:
Response:
Status:
Response:
>add/DENC_xxx'cr''lf']
>add/DENC_xxx'cr''lf']
Where: xxx = ON or OFF.
Modulator
Type Command:
Response:
Status:
Response:
>add/MT_xxxx'cr''lf']
>add/MT_xxxx'cr''lf']
Where: xxxx = INTL (INTELSAT OPEN NETWORK), EFD
(EF DATA CLOSED NETWORK), CSC (COMSTREAM
CLOSED NETWORK), FDC (FAIRCHILD CLOSED
NETWORK), or SDM51 (SDM51 COMPATIBLE).
Modulator
Encoder
Type Command:
Response:
Status:
Response:
>add/MET_xxx'cr''lf']
>add/MET_xxx'cr''lf']
Where: xxx = VIT (K-7 VITERBI ENCODER) or SEQ
(SEQUENTIAL ENCODER).
Transmit
BPSK Data
Ordering Command:
Response:
Status:
Response:
>add/TDA_xxx'cr''lf']
>add/TDA_xxx'cr''lf']
Where: xxx = NRM (STANDARD) or INV (NON-
STANDARD).
Modulator
Spectrum
Rotation Command:
Response:
Status:
Response:
>add/MSR_xxxx'cr''lf']
>add/MSR_xxxx'cr''lf']
Where: xxxx = NRM (normal spectrum) or INV (inverted
spectrum).
Reed-
Solomon
Encoder
Enable Command:
Response:
Status:
Response:
>add/RSEN_xxx'cr'lf']
>add/RSEN_xxx'cr'lf']
Where: xxx = ON or OFF.
Modulator
Spectrum
Rotation Command:
Response:
Status:
Response:
>add/MSR_xxxx'cr''lf']
>add/MSR_xxxx'cr''lf']
Where: xxxx = NRM (normal spectrum) or INV (inverted
spectrum).