Comtech EF Data MiniMac Installation ManualOperation Manual Operation Manual - Manual (Page 99)

MiniMAC Program MiniMAC Rack Management System
3–20 Rev. 0
3.7 Run MiniMAC Program
Start MiniMAC program as follows:
Click on: ILCNCS shortcut
or
Go to: Start\Programs\ILCNCS
Observe the three program windows at the bottom of the screen.
•
ILCNCS
•
COMM1
•
Logging
Note: When the program is initiated, it will require 15 minutes (approximately) for the
polling sequence to communicate with all the devices. Faults, alarms, communication
alarms will not be accurate until the polling sequence has completed one cycle.