Comtech EF Data MiniMac Installation ManualOperation Manual Operation Manual - Manual (Page 104)

Installation MINIMAC Rack Management System
2–2 Rev. 0
2.1 Unpacking
The MiniMAC system and the installation and operation manuals are packaged in pre-
formed, reusable, cardboard cartons containing foam spacing for maximum shipping
protection
C AU TIO N
Do not use any cutting tool that will extend more than 1 inch (2.5 cm) into
the container. This could cause damage to the equipment.
Unpack the MiniMAC System as follows:
1. Cut the tape at the top of the carton indicated by OPEN THIS END.
2. Remove the cardboard/foam space covering the unit.
3. Remove the unit, manual, and power cord from the carton.
4. Save the packing material for storage or reshipment purposes.
5. Inspect the equipment for any possible damage incurred during shipment.
6. Check the equipment against the packing list to ensure the shipment is correct.