Comtech EF Data MiniMac Installation ManualOperation Manual Operation Manual - Manual (Page 27)

MiniMAC Rack Management System Data
Rev. 0 A–9
A.2.5 Host File
The HOST File is used by Microsoft

TCP/IP for windows NT. It contains the mapping
of IP addresses to host names. If UINETMAN does not run in the services, it may be
necessary to add a new line to the HOST file. The path to the HOST file is:
Path: My Computer\C:\Winnt\system32\drivers\etc
Open the file labeled Hosts with the Notepad Program. Refer to Section A.1.1,
Figure A-3, the TCP/IP Address for the computer is located in the IP Address window.
The IP address and computer name should be added to the end of the host file.
Note: After adding the new line as shown, save the Host File prior to closing.