Comtech EF Data MiniMac Installation ManualOperation Manual Operation Manual - Manual (Page 30)

Data MiniMAC Rack Management System
A–12 Rev. 0
A.3 Debugging the Services
When necessary to troubleshoot the MiniMAC program, use the DEBUG command.
Perform the following:
Command Response
Open: CONTROL PANEL
Go to: SERVICES
Select: ILC NETWORK MANAGER and STOP SERVICE
Select: UINETWORK MANAGER and STOP SERVICE
Close: NETWORK Window
Close: CONTROL PANEL Window
Open DOS Prompt: Type: ilcnet -debug
Open DOS Prompt: Type: UINETMAN -debug
Start MiniMAC Program
When an error occurs, it will be displayed in the debug window.