Comtech EF Data MiniMac Installation ManualOperation Manual Operation Manual - Manual (Page 122)

Installation MINIMAC Rack Management System
2–20 Rev. 0
2.4.7 COMM 9 Installation
The COMM 9 Rack is identified as the REMOTE SITE (Figure 2-9). Install the
equipment as follows:
1. Install the RFT-12000 Terminal as specified in the Installation and Operation
Manual.
Command Response
Set Remote Address 12
Set Remote Communications Jumpers RS-485 (2-wire)
Note: The satellite modems and switch should be installed in a rack and
protected from the environment.
2. Install an SDM-300 Satellite Modem and identify as Primary #1. Set the Remote
Address to 1.
3. Install an SMS-301 Switch. Set the Remote Address to 11.
4. Install an SDM-300 Satellite Modem and identify as Backup #1. Set the Remote
Address to 9.
5. Install an UB-301 Breakout Panel as specified in the Installation and Operation
Manual.
6. Attach a customer-fabricated “Y” cable to the REMOTE port of the SMS-301
Switch, UB-300 (BOP), and the RFT-12000 Terminal.
UB-3 0 0
SM S -3 0 1
C u sto m e r F a b ric a te d
R F T -1 2 0 0 0
Te rm in a l
R e m o te S ite
R e m o te 2 6 -P in
C ircu la r
E S C 2 5 -P in
R e m o te
9 -P in