Comtech EF Data MiniMac Installation ManualOperation Manual Operation Manual - Manual (Page 89)

MiniMAC Program MiniMAC Rack Management System
3–10 Rev. 0
3.3.2.2 Install MOXA Properties
Select the following Properties as follows:
Selection Response
Board Type C3208
Memory Bank D4000
Interrupt No. 5
First Port COMM No. COMM11
Click on Done
Click on OK
Click on OK
Restart Computer
Note: All systems will have an identification file of all system parameters.
This data is stored in: A:\BACKUP\IPCONFIG.TXT
Verify the COMM ports with either:
HYPERTERM.EXE
COMMTEST. EXE.
Notes:
1. Commtest.exe will run the communications port just like the MiniMAC program.
2. Hyperterm is located within the Windows NT program.
3. Commtest is located at: C:\Program Files\ILCNCS\Commtest.Exe.