Comtech EF Data CDD-880 - Manual (Page 85)

CDD-880 Multi Receiver Router Revision 1
Ethernet-based Remote Product Management MN-CDD880
5–25
5.4.4.3.4 Configuration | ARP
Use this page to configure the CDD‐880 ARP (Address Resolution Protocol) parameters.
Figure 5‐13. Configuration | ARP page
Add Static ARP
Enter the desired IP and MAC addresses. Click [Add Entry] when done. The Index column
automatically increments to the next available number when the specified static ARP entry is
added to the ARP Table.
Delete Static ARP
Enter the Entry Index to Delete. Click [Delete Entry] to delete the specified entry index from the
ARP Table.
Flush Dynamic ARPs
Click [Flush Dynamic ARP] to delete all dynamically‐learned ARP entries.
ARP Table (Edit)
This section displays all current Static and Dynamic ARP entries, and allows to user to directly
edit the current Static ARP entries. Note the following: