Comtech EF Data CDD-880 - Manual (Page 78)

CDD-880 Multi Receiver Router Revision 1
Ethernet-based Remote Product Management MN-CDD880
5–18
5.4.4.3 Configuration Pages
Use the nested ‘Configuration’ pages to configure all unit parameters. Click the Interface, Mod,
ARP, Routing, Compression, or WAN tab to continue.
5.4.4.3.1 Configuration | Interface
Click the FE Mgt or GE tab to continue.
5.4.4.3.1.1 Configuration | Interface | FE Mgt
Use this page to configure the rear panel ‘ETHERNET | TRAFFIC / MANAGEMENT | GE’ 10/100/
1000 BaseT Gigabit Ethernet M&C port.
Figure 5‐9. Configuration | Interface | FE Mgt page
FE – Management Interface
• MAC Address – The MAC Address is read‐only and cannot be changed.
• IP Address / CIDR Mask – Use this box to enter the IP Address and CIDR (Classless Inter‐
Domain Routing) Subnet Mask. The valid range for the Subnet Mask is from 8 to 30.
1. The IP Address for the FE and GE interfaces must be different and on
separate subnets.
2. The FE and GE Ports are not currently isolated; the CDD‐880 can pass
traffic from one subnet to the other.
• Link Configuration – Use the drop‐down menu to select the line speed and duplex setting
for the ‘ETHERNET | TRAFFIC / MANAGEMENT | GE’ port. The available selections are: