Comtech EF Data CDD-880 - Manual (Page 24)

CDD-880 Multi Receiver Router Revision 1
Introduction MN-CDD880
1–6
1.3.3.2 Rear Panel
PROPER GROUNDING PROTECTION IS REQUIRED. The equipment must be connected
to the protective earth connection at all times. It is therefore imperative that the unit
is properly grounded, using the ground stud provided on the unit rear panel, during
installation, configuration, and operation.
• Sect. 3.2 CDD‐880 Cabling Connections
• Sect. 3.3 CDD‐880 Grounding and Power Connections
External cables are attached to connectors provided on the rear panel of the unit (Figure 1‐5).
(Top) Standard AC Unit
(Bottom) Optional 48V DC Unit
Figure 1-5. CDD-880 – Rear Panel View
1.3.3.2.1 Rear Panel Standard Features
The unit provides the following standard interfaces:
Data Interfaces:
• (1X) 10/100/1000 BaseT Gigabit Ethernet RJ‐45 Interface (‘ETHERNET TRAFFIC | GE’ port)
for Ethernet traffic.
• (1X) 10/100/1000 BaseT Gigabit Ethernet RJ‐45 Interface (‘ETHERNET TRAFFIC /
MANAGEMENT | GE’ port) for Ethernet Traffic or Ethernet‐based management and
control purposes (HTTP/Web and SNMP).
• (1X) DB‐9F EIA‐232 connector for serial remote control (‘CONSOLE’ port).
Tx (Transmit )IF Interfaces
• (1X) Type ‘N’ female connector for 50Ω L‐Band (950 to 2150 MHz)
Power Interface
• 115/230 VAC Primary Input Power Supply with Press‐fit Fuse Holder