Comtech EF Data CDD-880 - Manual (Page 108)

CDD-880 Multi Receiver Router Revision 1
Serial-based Remote Product Management MN-CDD880
6–8
6.3 Remote Commands and Queries
The Serial Command Line interface (CLI) (the Controller), shown previously in , is used to issue remote commands and queries to the
CDD‐880 (the Target). From the CLI command prompt CDD‐880> type in the command or query packet, using the format explained
previously, for transmission to the CDD‐880.
For example: CDD‐880><0000/LC1=3[cr]
The table that follows provides a ‘quick reference‘ to the Instruction Codes available at present for M&C of the CDD‐880. The ‘C’ and ‘Q’
columns, when marked with an ‘X’, denote whether that Instruction Code is Command Only, Query Only, or Command and Query.
INSTRUCTION
CODE
USED TO... C Q Page
DPW Set default passwords X 5‐9
IG1 Set or query the IP Address and network prefix for the GE 10/100/1000 Gigabit Ethernet Port X X 5‐9
IPA
Set or query the IP Address and network prefix for the GE 10/100/1000 Gigabit Ethernet Traffic
/ Management port
X X 5‐10
LC1 Set or query the link configuration for the GE 10/100/1000 Gigabit Ethernet Port X X 5‐10
MAC Query the unique router MAC Address X 5‐10
MG1 Query the unique GE port MAC Address X 5‐10
MLC Set or query the link configuration for the FE Port X X 5‐10
NPS Query the negotiated port speeds for the GE and FE ports X 5‐11
SRC Set or query the SNMP Read Community String X X 5‐11
SWC Set or Query the SNMP Write Community String X X 5‐11