Comtech EF Data CDD-880 - Manual (Page 82)

CDD-880 Multi Receiver Router Revision 1
Ethernet-based Remote Product Management MN-CDD880
5–22
• Rx Spectrum Invert – Use the drop‐down menu to select Spectrum Inversion operation as
either Normal or Inverted.
• Rx Descram – Use the drop‐down menu to select Rx Descrambling as either Off or Normal.
• Eb/No Alarm Pt (0.1‐16.0) – Enter the Eb/No Alarm Point value, in dB. This value, as
calculated by the demodulator, is the energy per bit (Eb) divided by the noise spectral
density (No).
When ACM is enabled, the CDD‐880 will issue an alarm only if the
demodulator is at the lowest available MODCOD (BPSK).
• Circuit ID (4‐24) – Enter an identification label for the demod, from four to 24 characters.
Click [Submit] to save.
• Acquisition Range (1‐200) – Enter the Acquisition Range value, in kHz. Note that the range is
dependent on the current symbol rate of the demodulator. Click [Submit] to save.