Compuprint 9058 Programmer Manual - Manual (Page 9)

EPSON/IBM Mode
A78408098-003 7
ESC 5
Sets an automatic line feed after a carriage return. (IBM)
ASCII Code ESC 5 n
Hexadecimal Value 1B 35 n
Decimal Value 27 53 n
If n is equal to 1, this command sets an automatic line feed on
receiving of a CR code. If n is equal to 0, this command cancels the
automatic line feed.
n Automatic line feed
0 Disabled
1 Enabled
ESC J
Advances paper n/180 inch. (EPSON)
ASCII Code ESC J n
Hexadecimal Value 1B 4A n
Decimal Value 27 74 n
Range 1 < n < 255
This is a terminator code; it therefore causes the current contents of
the print buffer to be printed out before performing a single line feed
of n/180 inch. This command is cancelled after the line feed has been
performed. The printing will restart after a line feed from the column
at which the command was sent.
LF
Line Feed. (IBM, EPSON)
ASCII Code LF
Hexadecimal Value 0A
Decimal Value 10
This is a terminator code; it therefore causes the current contents of the
print buffer to be printed out before advancing the paper by one line at