Compuprint 9058 Programmer Manual - Manual (Page 19)

EPSON/IBM Mode
A78408098-003 17
Character Width Horizontal Spacing Range of columns
3 0 < n < 67
6 cpi 0 < n < 80
7.5 cpi 0 < n < 100
8.5 cpi 0 < n < 114
Double Width
10 cpi 0 < n < 134
10 cpi 0 < n < 134
12 cpi 0 < n < 160
15 cpi 0 < n < 201
17 cpi 0 < n < 229
Normal
20 cpi 0 < n < 255
Any value outside the accepted range is ignored and the previous
setting remains in effect. The left margin must be smaller than the
right margin. The physical position set for the left margin does not
change if the horizontal spacing is modified. This command overrides
the menu setting.
ESC N
Sets the skipover perforation to n lines. (IBM, EPSON)
ASCII Code ESC N n
Hexadecimal Value 1B 4E n
Decimal Value 27 78 n
Range 1 < n < 127 (EPSON mode)
1 < n < 225 (IBM mode)
The skipover perforation is the sum of top and bottom margins values
at the selected vertical spacing. The n parameter must be less than
the current form length. The skipover is memorized as physical
position on the page. It is cancelled by ESC O or changing the form
length.
The skipover value, when accepted, will set the top and bottom
margins according to the operator panel setting (see User Manual):