Compuprint 9058 Programmer Manual - Manual (Page 63)

EPSON/IBM Mode
A78408098-003 61
ESC [ K
Sets initial conditions. (IBM 2391 only)
ASCII Code ESC [ K n
1
n
2
init id parm
1
parm
2
Hexadecimal Value 1B 5B 4B n
1
n
2
init id parm
1
parm
2
Decimal Value 27 91 75 n
1
n
2
init id parm
1
parm
2
This command causes the printer to reset to its initial status:
n and n The n and n parameters specify the number of bytes in
the escape sequence normally, n =1,3 or 4 and n = always
0.
init The init parameter specifies to which condition the printer
should initialize, normally init = 0,1,4,5, 254,255:
0
Initializes printer to user-default settings. The
download font remains unchanged. If parameters
are specified, they will overwrite the default
settings. If the emulation mode is changed, the
download font will be initialized. This command
will only copy data from the selected macro, add
parameter changes, if any, and store in working
RAM; the data stored in the macro’s non-volatile
RAM will not be affected.
1 Initializes printer to user-default settings. The
download font is initialized. If parameters are
specified, they will overwrite the default settings.
This command will only copy data from the selected
macro, add parameter changes, if any, and store in
working RAM; the data stored in the macro’s non-
volatile RAM will not be affected.