Compuprint 9058 Programmer Manual - Manual (Page 134)

The Parallel Interface
A78408098-003 C.5
Signal
Name Pin N° Source Description
AUTOFEEDXT 14 HOST Active low level signal. Indicates whether
a LF is performed after a CR or not.
GND 16 - Logical ground level (0V).
CHASSIS
GND 17 - Frame ground.
+ 5 VDC 18 PRINTER Is the DC voltage supplied by a
component that limits the driven
capability up to 100 mA.
SIGNAL GND 19-30 - Signal ground.
INIT 31 HOST Active low level signal. Indicates, that
the printer is initializing. The BUSY
signal is forced high.
ERROR 32 PRINTER When low, this signal indicates that the
printer is off-line, there is an off-line
request from the operator panel, or the
printer is in an error state because of:
paper jam, paper end or paper size
error, engine error, output bin full or
cover open condition.
+5V 35 PRINTER Pulled up to signal.
SELECTIN 36 HOST Active low level signal. Enables the
printer
.
The pins 1 to 14 of the printer are connected to the pins with the same
number of the parallel port of the host.
The pins 19 to 30 of the printer are connected to the pins 18 to 25 of the
parallel port of the host.
The pins 31, 32 and 36 of the printer are connected respectively to the
pins 16, 15 and 17 of the parallel port of the host.