Compuprint 9058 Programmer Manual - Manual (Page 7)

Introduction
A78408098-003 5
ESC K Normal density dot graphics printing (60 dpi). (IBM,
EPSON) 53
ESC l Sets left margin (10 cpi). (EPSON) 16
ESC L Double density dot graphics printing (120 dpi). (IBM,
EPSON) 54
ESC M Selects 10.5 point, 12 cpi. (EPSON) 35
ESC m Selects magenta ribbon band. (IBM) 35
ESC N Sets the skipover perforation to n lines. (IBM, EPSON) 17
ESC O Disables the skipover perforation. (IBM, EPSON) 18
ESC P Selects 10.5 point, 10 cpi. (EPSON) 36
ESC P Sets or cancels proportional printing. (IBM) 36
ESC p Sets or cancels proportional printing. (EPSON) 36
ESC Q Sets the right margin (10 cpi). (EPSON) 19
ESC Q Deselects Printer. (IBM) 59
ESC R Sets all tabs to power-on settings. (IBM) 19
ESC r Selects print color (if the color ribbon cartridge is installed).
(EPSON) 37
ESC R Selects an international character set. (EPSON) 46
ESC S Sets subscript or superscript printing. (IBM, EPSON) 38
ESC s Sets and resets Quiet printing. (EPSON) 39
ESC SI Selects condensed mode. (IBM, EPSON) 38
ESC SO Sets double width printing (one line). (IBM, EPSON) 39
ESC SP Sets intercharacter space. (EPSON) 20
ESC T Cancels subscript or superscript printing. (IBM, EPSON) 39
ESC t Selects characters table. (EPSON) 46
ESC U Sets printing direction. (IBM, EPSON) 64
ESC W Sets or cancels double width printing. (IBM, EPSON) 40
ESC w Sets or cancels double height printing. (EPSON) 40
ESC X Sets left and right margins. (IBM) 20
ESC x Selects Letter Quality or Draft. (EPSON) 41
ESC y Selects yellow ribbon band. (IBM) 41
ESC Y Double density dot graphics printing at double-speed
graphics (120 virtual dpi). (IBM, EPSON) 55
ESC Z Quadruple density dot graphics printing (240 virtual dpi).
(IBM, EPSON) 55
FF Advances paper to the top of the next page. (IBM, EPSON) 21
HT Horizontal Tab. (IBM, EPSON) 21
LF Line Feed. (IBM, EPSON) 7
SI Sets condensed printing. (IBM, EPSON) 41
SO Sets double width printing (one line). (IBM, EPSON) 42
VT Vertical Tab. (IBM, EPSON) 22