Beisler 1360-4 - Manual (Page 83)

D-14
Programming Instructions Automatic Multi-Head Serging Machine 1365-4 Beisler GmbH
D.3
Programming
27 TILL ROLLER STOP/CUTTER
Distance along which the roller travels before it stops for chain cut-
ting
28 ROLLER STOP DURATION
Period during which the roller stops for chain cutting
29 ROLLER SPEED [99]
Rotating speed of the roller
30 ROLLING DISTANCE [18]
Major parameter/basic setting of the roller transport distance for
transferring the sewing piece to the cross transport. The retaining
screw is the reference point
Ä Cross transport
Use this value to set the transport distance from the A machine to the B
machine.
37 CLAMP TRANSFER POSITION
The point where the cross transport picks up the sewing piece from
the A machine, i.e. the distance between the cross transport initiator
and the left edge of the stamp mounting
38 CLAMP WAITING POSITION
The wait position where the cross transport stops before the B ma-
chine
39 CLAMP STOP AFTER PH.14
Major parameter/basic setting of the transport distance from the wait
position before the swing arm picks up the sewing piece at the B
machine
40 BLIND SECTION OF PH.14
Photocell response delay for compensating gaps in the sewing pie-
ce
41 CLAMP SPEED A -> B HEAD
Cross transport travel speed
42 CLAMP SPEED B -> A HEAD
Cross transport return speed
43 WAIT POS->TO SEWING.POS
Distance along which the sewing piece is sewn in the B machine be-
fore the following sewing piece moves from the wait position to the
swing arm (photocell 15 is the reference point)