Beisler 1360-4 - Manual (Page 32)

Operating Instructions Automatic Multi-Head Serging Machine 1365-4 Beisler GmbH
B-22
B.3
Operation
Changing values
1. Select the function at the A machine or B machine:
• Press the c or f key
s s
until the symbol assigned to the input field appears on a black back-
ground.
2. Increase or reduce the value using the arrow keys:
• Press the & or / key
3. Confirm input:
• Press the (key
v Top transport
Within a sewing program, the width distribution can be corrected by quick
adjustment of the top transport both at the A machine and at the B machine.
To achieve this, the position of the top transport unit to the main transport
unit can be changed within a value range of -19 to +19. This setting affects
only that section of the seam for which fullness has been enabled.
w Differential transport
The position of the differential transport unit to the main transport unit of
the sewing unit can also be changed by quick adjustment within a value
range of -19 to +19. This setting affects only that section of the seam for
which fullness has been enabled.
# Puller speed
The photocell determines the deviation of the fabric contour from the ideal
routing and readjusts the puller speed, as required.
• If the sewing pieces are shifted sideways away from the stop, the pul-
ler speed is too high,
• if the sewing pieces warp at the stop, the puller speed is too low.
The frequency for adapting the puller speed is set with the program con-
trol.
The basic speed of the puller can be changed by using the input field.
x Roller
The parameter changes the length of the distance along which the roller
transports the sewing piece from the A machine to the point where the cross
transport picks it up or at the B machine from the worktable to the stacker.