Beisler 1360-4 - Manual (Page 60)

C-20
Service Instructions Automatic Multi-Head Serging Machine 1365-4 Beisler GmbH
C.5
Maintenance
C.5.14 Adjusting the cross transport and swing arm stamps
Fig. 13: The two stamps of the cross transport
1 and the two stamps of the swing arm 5
are matched to fit the width of the lower third of
the trousers panel. The adjustment of the
stamps should ensure that they are lowered
onto the trousers panel in close vicinity to the
fabric edges.
The nut 4 in the guide rail 5 secures the
pneumatic cylinder 2 of the stamp.
To change the position of the stamps:
1. Loosen the nut at the pneumatic cylinder.
2. Push the stamp to the desired position (the
distance between the outer edge of the
stamp and the fabric edge should be ap-
prox 5-10 mm).
3. Tighten the nut.
Fig. 13