Start-up – Beisler 1360-4 User Manual
Page 47
C-7
Service Instructions Automatic Multi-Head Serging Machine1365-4
Beisler GmbH
C.3.4 Power supply
The machine is connected to a power supply system of 230 V ± 10 % at
50/60 Hz.
WARNING - Electric shock!
Contact with current-carrying components may cause a le-
thal electric shock. Check plug and cable before connec-
ting machine to power supply system.
Do not use damaged plugs, sockets or cables to con-
nect the machine to the power supply system!
Before connecting the machine to the power supply sy-
stem, check to see if the ratings of the power supply
system in the operating room correspond with the ra-
tings on the nameplate at the rear of the machine.
If the ratings for voltage (V) and maximum current (A)
do not match, the machine must not be connected.
Insert the grounding plug into a properly grounded and
fused power socket.
Make sure that the power supply cable is not subjected
to tensile or pressure forces.
Route the power supply cable in a way that ensures
free access to and around the machine.
NOTE - Works to the electrical system!
Works to the electrical system of the machine must only
be carried out by qualified and authorized expert person-
nel. Tampering with the machine without authorization will
make the warranty void.
C.3
Start-up