Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part1 - Manual (Page 95)

USEFUL FUNCTIONS
Se
wi
n
g Ba
sics
93
2
■ Adjusting the Brightness of the
Guideline Marker
a
Follow steps from
a
to
c
to display the
“Guideline Marker Adjustment” screen.
b
Use or to adjust the brightness of
the guideline marker.
→ Set the brightness of the guideline marker from “1”
for a dim marker, to “5” for the brightest marker, on
the fabric.
c
Press twice to return to the original
screen.
Pivoting
If the pivot function is selected, the machine stops
with the needle lowered (in the fabric) and the
presser foot is automatically raised to an
appropriate height when the “Start/Stop” button is
pressed. When the “Start/Stop” button is pressed
again, the presser foot is automatically lowered
and sewing continues. This function is useful for
stopping the machine to rotate the fabric.
a
Select a stitch.
CAUTION
• When the pivot setting is selected, the
machine starts when the “Start/Stop” button is
pressed or the foot controller is pressed down
even if the presser foot has been raised. Be
sure to keep your hands and other items away
from the needle, otherwise injuries may occur.
Memo
• When the pivot setting is selected, the
height of the presser foot when sewing is
stopped can be changed according to the
type of fabric being sewn. Press
to
display “Pivoting Height” of the settings
screen. Press or to select one of the
three heights (3.2 mm, 5.0 mm or 7.5 mm).
To raise the presser foot further, increase
the setting. (Normally, 3.2 mm is set.)
Note
• The “Needle Position – Up/Down” of the
settings screen, must be set in the down
position for the pivot function to be
used. When “Needle Position – Up/Down” is
set in the raised position , appears
as light gray and cannot be used.
• The pivot function can only be used with
stitches where presser foot “J” or “N” is
indicated in the upper-left corner of the
screen. If any other stitch is selected,
appears as light gray and is not available.
• If the pivot function is selected, and
beside “Presser Foot Height” in the settings
screen are not available and the setting
cannot be changed.