Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part1 - Manual (Page 70)

CHANGING THE PRESSER FOOT
68
Removing the Presser Foot
a
Press the “Needle Position” button to raise
the needle.
b
Press to lock all keys and buttons.
* If the message “OK to automatically lower the
presser foot?” appears on the LCD screen, press
to continue.
c
Raise the presser foot lever.
d
Press the black button on the presser foot
holder and remove the presser foot.
a Black button
b Presser foot holder
Attaching the Presser Foot
a
Place the new presser foot under the
holder, aligning the foot pin with the notch
in the holder. Lower the presser foot lever
so that the presser foot pin snaps into the
notch in the holder.
a Notch
b Pin
b
Press to unlock all keys and buttons.
c
Raise the presser foot lever.
CHANGING THE PRESSER FOOT
CAUTION
• Always press on the screen to lock all keys and buttons before changing the presser foot. If is
not pressed and the “Start/Stop” button or another button is pressed, the machine will start and may
cause injury.
• Always use the correct presser foot for the selected stitch pattern. If the wrong presser foot is used, the
needle may strike the presser foot and bend or break, and may cause injury.
• Only use presser feet made for this machine. Using other presser feet may lead to accident or injury.
b
a
CAUTION
• Make sure that the presser foot is installed in
the correct direction, otherwise the needle
may strike the presser foot, breaking the
needle and causing injuries.