Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part1 User Manual

Page 106

USING SENSOR FUNCTIONS WITH SEWING STITCH

104

With the sensor pen, touch the location to

be specified as the sewing end point.

→ The distance from the current needle position to the

touched location appears.

a It shows how many times you need to touch the

sewing end point, once or twice.

b Press to erase the specified sewing end point.
c Press to begin sewing at the beginning of the

pattern.

d Press to stop specifying a setting with the sensor

pen.

e Press when sewing the same distance as the

previous time to recall the previous setting.

→ See “Reusing the Previous Setting” on page 106.
f Press to select whether or not sewing is ended

with a complete pattern.

→ See “Stitch End Mode Key” on page 104.

Stitch End Mode Key

Touch once

Touch twice

Note

• The displayed distance is not the length of a

straight line connecting the current needle
position and the location touched with the
sensor pen. It is the length of a
perpendicular intersection for the location
touched with the sensor pen and the sewing
line.

a Displayed distance

• The following error message appears if the

area outside of the sensor pen touch range

is touched. Press

, and then touch

within the sensor pen touch range.

• When sewing with this setting, be sure to

gently hold the fabric and feed it straight.

• When using the sensor pen to specify the

sewing end point, be sure to hold the pen in
the same way as when it was calibrated,
otherwise the actual end point may be
different from the point that you specified.

• For best results, sew test stitching using the

same material and stitch pattern as those in
the actual project.

The end of stitching is not adjusted.
When the end point is reached, sewing
stops immediately, even if the stitch
pattern is not complete.

The length of the stitch pattern is
adjusted so that sewing will stop at the
specified end point with a complete
pattern.