Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part1 - Manual (Page 135)

SEWING THE STITCHES
U
tili
ty
S
tit
ch
es
133
3
a Free motion quilting foot “C”
→ When stitch Q-01 or 1-31 is selected, free motion
quilting foot “C” is indicated in the upper-left corner
of the screen.
d
Remove the presser foot holder (see page
69).
e
Attach free motion quilting foot “C” at the
front with the presser foot holder screw
aligned with the notch in the quilting foot.
a Presser foot holder screw
b Notch
f
Hold the quilting foot in place with your
right hand, and tighten the presser foot
holder screw using the multi-purpose
screwdriver with your left hand.
a Presser foot holder screw
g
Use both hands to stretch the fabric taut,
and then move the fabric at a consistent
pace in order to sew uniform stitches
roughly 2.0-2.5 mm (approx. 1/16 - 3/32
inch) in length.
a Stitch
h
Press to cancel the free motion sewing
mode.
→ Rotate the handwheel toward you
(counterclockwise) to raise the feed dogs.
i
After sewing, make sure to remove the
straight stitch needle plate and presser foot
“C”, and reinstall the regular needle plate
and the needle plate cover.
Note
• Make sure that the quilting foot is attached
properly and not slanted.
a
b
a
CAUTION
• Be sure to securely tighten the screws with the
included multi-purpose screwdriver.
Otherwise, the needle may touch the quilting
foot, causing it to bend or break.
Note
• Free motion open toe quilting foot “O” can
also be used with the straight stitch needle
plate. We recommend using free motion
open toe quilting foot “O” with free motion
sewing of fabrics of uneven thicknesses.
• When using the straight stitch needle plate,
all straight stitches become middle needle
position stitches. You cannot change the
needle position using the width display.
Memo
• Normally, the feed dogs are raised for
regular sewing.
• Do not be discouraged with your initial
results. The technique requires practice.