Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part1 User Manual
Page 79

NEEDLE CALIBRATION USING THE BUILT IN CAMERA
G
etting
Re
ad
y
77
1
3. Affix white sticker on needle dropping
point area.
a White sticker
4. Press
to initiate the calibration
process. For safety please make sure area
around needle is clear prior to pressing
.
→ Setting the needle drop point begins.
d
The operation is finished when “OK”
appears. If “NG” appears, remove the
sticker, and then follow the on-screen
instructions to repeat steps 3 and 4 of
step
c
. If multiple attempts to set the
position are not successful, contact your
nearest Baby Lock retailer.
e
Remove the sticker, and then turn off the
machine.
Note
• Use a new sticker. The camera needle
position cannot be set correctly if there is a
hole in sticker or if it is dirty. If you have no
new stickers, contact your nearest Baby
Lock retailer.