Baby Lock Destiny (BLDY) Instruction & Reference Guide-Part1 - Manual (Page 78)

NEEDLE CALIBRATION USING THE BUILT IN CAMERA
76
Setting the camera needle position is essential
when you use camera function. It is not necessary
to perform this operation each time, but we
recommend performing it when the needle is
changed. Use the white stickers (solid) included
with the machine.
a
Hold your finger firmly on the LCD screen,
and then turn on the machine.
→ The following screen appears.
b
Press the “Automatic Threading” button.
→ Camera needle position setting screen appears.
c
Follow the on-screen instructions to
complete the procedure.
1. Raise needle bar to its highest position.
2. Remove presser foot and replace needle
with a new embroidery needle standard
size 75/11 or 90/14.
NEEDLE CALIBRATION USING THE BUILT IN
CAMERA
Note
• Be careful not to touch the LCD screen prior
to Step
b
below.
• This function can be performed with or
without embroidery unit attached to
machine. If attached, message screens will
appear regarding movement of embroidery
unit.
+1 +4
+5 +8
+11 +13
+9
+2 +3
+10
7+
6+
12+
Note
• The “Needle Position” button cannot be
used while setting the camera needle
position. Turn the handwheel
counterclockwise to move the needle bar.