Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 80)

Function Reference 4-39
Return Values
0 Successful.
703-793 A motion control error occurred. For errors
between 703-793. The operator corrects the
printer condition. Then the application must call
pclClearError to reset the Motion Control
subsystem. Refer to the MPCLII Packet
Reference Manual for more information.
Other non-zero An error occurred. Refer to the MPCLII Packet
Reference Manual for more information.
Example
#include
#include
#include "mmsultra.h"
void GetSupplyType(unsigned short *);
void GetStockLength(unsigned short *);
void GetStockWidth(unsigned short *);
unsigned short main(void)
{
unsigned short usStatus; // Printer completion status
unsigned short usStockWidth; // Stk. width in 1/100th inches
unsigned short usStockLength; // Stk. length in 1/100th inches
unsigned short usSupplyType; // Supply type, 0 - 2
unsigned short status = 0; // Print subsystem init. status
PRINTINIT rConfig; // Print subsystem data struct.
rConfig.lpuchFntAddr = 0;
rConfig.ulFntSize = 0;
status = pcl I nit(&rConfig);
if (status != 0)
{
printf("Init Failed \nError: %d", status);
exit(1);
}
pclPaperInfo(&usStockLength, &usStockWidth,
&usSupplyType);