Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 28)

Developing Applications 3-1
D E V E L O P I N G A P P L I C A T I O N S
Developing applications is a long, detailed process. You cannot
just write the application in Microsoft C/C++. You must also
understand the whole picture. For example, you must create
MPCLII packets and assess the application’s memory needs.
This chapter describes this process. Following is a summary:
1. Create any needed MPCLII packets (if your application
prints labels).
2. Assess the application’s memory needs.
3. Write the application.
4. Build (compile and link) the application.
5. Run REMSERV on the PC and REMDISK on the printer to
enable the printer to access a disk drive on the PC.
6. Test the application with the printer attached to the PC.
7. Create a disk image.
8. Load the disk image into the printer’s flash ROM.
9. Quit REMSERV and REMDISK.
10. Test the application with the printer detached from the PC.
3