Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 37)

3-10 Programmer’s Manual
C r e a t i n g D i s k I m a g e s
Before you can load the application into the printer, you must
create a disk image. To do so, gather the files required by the
application in a separate directory. This directory may have
s ub-directories. Then, you must run the ROMDISK Utility. See
“ROMDISK” in Chapter 7 for more information.
CAUTION
Be v e r y careful when gathering the files to
include in your disk image. You must
include all files needed to boot the printer
and run the application.
Disk image file sizes cannot be larger than 832K (for the first
flash ROM) and 932K (for the second flash ROM).
If the second flash ROM does not contain a DOS file system
(even an empty one), the printer does not load the disk image.
DOS assigns drive letters in the order you
specify the entries in CONFIG.SYS. If you
use REMDISK outside of CONFIG.SYS, DOS
assigns it the next letter after the ones
specified in CONFIG.SYS.
Using the First Flash ROM Only
The first flash ROM requires the following files (others are
optional):
♦
COMMAND.COM
♦
REMDISK.EXE
♦
LCD.COM
♦
AUTOEXEC.BAT (at a minimum, this file must contain one
line containing
LCD Y C ).